ISO IEC 7810:2003 pdf download – Identification cards — Physical characteristics.
1 Scope This International Standard is one of a series of standards describing the characteristics for identification cards as defined in the definitions clause and the use of such cards for international interchange. This International Standard specifies the physical characteristics of identification cards including card materials, construction, characteristics, and dimensions for four sizes of cards. ISO/IEC 10373-1 specifies the test procedures used to check cards against the parameters specified in this International Standard. This International Standard specifies the requirements for cards used for identification. It takes into consideration both human and machine aspects and states minimum requirements. It is the purpose of this series of standards to provide criteria to which cards shall perform. No consideration is given within these standards to the amount of use, if any, experienced by the card prior to test. Failure to conform to specified criteria should be negotiated between the involved parties. NOTE 1 Numeric values in the SI and/or Imperial measurement system in this International Standard may have been rounded off and therefore are consistent with, but not exactly equal to, each other. Either system may be used, but the two should not be intermixed or reconverted. The original design was made using the Imperial measurement system. NOTE 2 A different standard for thin flexible cards exists. Thin flexible cards are not within the scope of this International Standard. 2 Conformance An identification card is in conformance with this International Standard if it meets all mandatory requirements specified herein. Unless otherwise specified default values apply. 3 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO/IEC 10373-1:1998, Identification cards — Test methods — Part 1: General characteristics tests NOTE The ID-000 size card size was first defined by ENV 1375-1, Identification card systems — Intersector integrated circuit(s) card additional formats — Part 1: ID-000 card size and physical characteristics. 4 Terms and definitions For the purposes of this document, the following terms and definitions apply.
4.1 identification card card identifying its holder and issuer which may carry data required as input for the intended use of the card and for transactions based thereon 4.2 signature panel special area on the card intended to have a signature applied 4.3 warpage deviation from flatness 4.4 normal use use as an identification card (see 4.1) involving equipment processes appropriate to the card technology, and storage as a personal document between equipment processes 4.5 ID-1 nominally 85,60 mm (3.370 in) wide by 53,98 mm (2.125 in) high by 0,76 mm (0.030 in) thick 4.6 ID-2 nominally 105 mm (4.134 in) wide by 74 mm (2.913 in) high by 0,76 mm (0.030 in) thick 4.7 ID-3 nominally 125 mm (4.921 in) wide by 88 mm (3.465 in) high by 0,76 mm (0.030 in) thick
ISO IEC 7810:2003 pdf download – Identification cards — Physical characteristics
