ISO 24162:2022 pdf download – Test method for energy consumption of refuse collection vehicles.
1 Scope This document specifies a uniform, reproducible testing process for various drive units, chassis, constructions and lifting devices for the refuse collection vehicles described in EN 1501 (all parts, excluding EN 1501-4), with which a comparison for energy consumption can be performed. This specification defines criteria for a reference area with regard to a synthesized tour (test circuit). This therefore serves to determine a representative test circuit and/or data for a software calculation tool, e.g. VECTO 1) . NOTE VECTO (Vehicle Energy Consumption calculation TOol) is a simulation tool that has been developed by the European Commission for determining CO 2 emissions and fuel consumption from heavy duty vehicles with a gross vehicle mass above 3 500 kg. URL: https:// ec .europa .eu/ clima/ policies/ transport/ vehicles/ vecto _en #tab -0 -0 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 1501-1, Refuse collection vehicles — General requirements and safety requirements — Part 1: Rear loaded refuse collection vehicles EN 1501-2, Refuse collection vehicles — General requirements and safety requirements — Part 2: Side loaded refuse collection vehicles EN 1501-3, Refuse collection vehicles — General requirements and safety requirements — Part 3: Front loaded refuse collection vehicles EN 1501-5, Refuse collection vehicles — General requirements and safety requirements — Part 5: Lifting devices for refuse collection vehicles 3? Terms? and? definitions For the purposes of this document, the following terms and definitions apply. ISO and IEC maintain terminology databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https:// www .iso .org/ obp — IEC Electropedia: available at https:// www .electropedia .org/ 3.1 energy consumption amount of mechanical, electrical, hydraulic and pneumatic energy which is needed for the defined cycles of the body
3.2 load simulation valve valve in the hydraulic circuit of the compaction unit (packing unit) of an RCV for generating a hydraulic load 3.3 pre-control valve valve in the hydraulic circuit for controlling the load simulation valves (3.2) 3.4 ballasting loading of the collection container for an RCV and the refuse collection container with mass 3.5 measuring turbine measuring device for the consumption of fuel using differential measurement in the fuel system 3.6 measurement run sum of all test cycles on the test track 3.6.1 reference run run of the test cycle (3.11) only with the chassis and without any further energy-consuming components 3.6.2 compaction run run of the test cycle (3.11) with the chassis and the bodywork with one loading cycle
ISO 24162:2022 pdf download – Test method for energy consumption of refuse collection vehicles
