ISO 17194:2022 pdf download – Structural adhesives — Standard database of properties.
1 Scope This document specifies a set of basic properties commonly required for the selection and use of structural adhesives in different applications. ISO standard test methods and test conditions are also reviewed for the measurement of these data to facilitate traceability of recorded values (see Introduction). 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 62, Plastics — Determination of water absorption ISO 527-1, Plastics — Determination of tensile properties — Part 1: General principles ISO 527-2, Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion plastics ISO 868, Plastics and ebonite — Determination of indentation hardness by means of a durometer (Shore hardness) ISO 1183 (all parts), Plastics — Methods for determining the density of non-cellular plastics ISO 1817, Rubber, vulcanized or thermoplastic — Determination of the effect of liquids ISO 2555, Plastics — Resins in the liquid state or as emulsions or dispersions — Determination of apparent viscosity using a single cylinder type rotational viscometer method ISO 2577, Plastics — Thermosetting moulding materials — Determination of shrinkage ISO 3219 (all parts), Plastics — Polymers/resins in the liquid state or as emulsions or dispersions — Determination of viscosity using a rotational viscometer with defined shear rate ISO 11339, Adhesives – T-peel test for flexible-to-flexible bonded assemblies ISO 4587, Adhesives — Determination of tensile lap-shear strength of rigid-to-rigid bonded assemblies ISO 6721-4, Plastics — Determination of dynamic mechanical properties — Part 4: Tensile vibration — Non-resonance method ISO 6721-5, Plastics — Determination of dynamic mechanical properties — Part 5: Flexural vibration — Non-resonance method ISO 9142, Adhesives — Guide to the selection of standard laboratory ageing conditions for testing bonded joints ISO 10364, Adhesives — Determination of pot life (working life) of multi-component adhesives ISO 11343, Adhesives — Determination of dynamic resistance to cleavage of high-strength adhesive bonds under impact wedge conditions — Wedge impact method ISO 11357-2, Plastics — Differential scanning calorimetry (DSC) — Part 2: Determination of glass transition temperature and step height
ISO 11359-2, Plastics — Thermomechanical analysis (TMA) — Part 2: Determination of coefficient of linear thermal expansion and glass transition temperature ISO 15166-1, Adhesives — Methods of preparing bulk specimens — Part 1: Two-part systems ISO 15166-2, Adhesives — Methods of preparing bulk specimens — Part 2: Elevated-temperature-curing one-part systems ISO 17212, Structural adhesives — Guidelines for the surface preparation of metals and plastics prior to adhesive bonding ISO 25217, Adhesives — Determination of the mode 1 adhesive fracture energy of structural adhesive joints using double cantilever beam and tapered double cantilever beam specimens IEC 62631-3-1, Dielectric and resistive properties of solid insulating materials – Part 3-1: Determination of resistive properties (DC methods) – Volume resistance and volume resistivity – General method IEC 60243-1, Electrical strength of insulating materials — Test methods — Part 1: Tests at power frequencies 3? Terms? and? definitions No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https:// www .iso .org/ obp — IEC Electropedia: available at https:// www .electropedia .org/
ISO 17194:2022 pdf download – Structural adhesives — Standard database of properties
