ISO IEC 10373-3:2010 pdf download – Identification cards — Test methods — Part 3: Integrated circuit cards with contacts and related interface devices.
1 Scope This part of ISO/IEC 10373 defines test methods for characteristics of integrated circuit cards with contacts and related interface devices according to the definition given in ISO/IEC 7816. Each test method is cross-referenced to one or more base standards, which can be ISO/IEC 7810 or one or more of the supplementary International Standards that define the information storage technologies employed in identification card applications. NOTE Criteria for acceptability do not form part of this part of ISO/IEC 10373 but will be found in the International Standards mentioned above. This part of ISO/IEC 10373 defines test methods which are specific to integrated circuit technology with contacts. ISO/IEC 10373-1 defines test methods which are common to one or more card technologies and other parts define other technology-specific tests. Test methods defined in this part of ISO/IEC 10373 are intended to be performed separately and independently. A given card is not required to pass through all the tests sequentially. The test methods defined in this part of ISO/IEC 10373 are based on ISO/IEC 7816-3. Conformance of cards and IFDs determined using the test methods defined in this part of ISO/IEC 10373 does not preclude failures in the field. Reliability testing is outside the scope of this part of ISO/IEC 10373. This part of ISO/IEC 10373 does not define any test to establish the complete functioning of integrated circuit cards. The test methods require only that the minimum functionality be verified. Minimum functionality is defined as follows. ⎯ Any integrated circuit present in the card continues to show an Answer to Reset response which conforms to the base standard. ⎯ Any contacts associated with any integrated circuit present in the card continue to show electrical resistance which conforms to the base standard. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO/IEC 7810:2003, Identification cards — Physical characteristics ISO/IEC 7816-3:2006, Identification cards — Integrated circuit cards — Part 3: Cards with contacts — Electrical interface and transmission protocols
3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 card integrated circuit card with contacts as defined in ISO/IEC 7816 3.2 DUT device under test card or IFD that is subject to testing 3.3 etu-factor parameters negotiable by protocol and parameters selection (PPS), described in ISO/IEC 7816-3:2006, 6.3.1 3.4 IFD interface device related to integrated circuit cards with contacts as defined in ISO/IEC 7816-3 3.5 normal use use as an identification card, as defined in ISO/IEC 7810:2003, 4.1, involving equipment processes appropriate to the card technology and storage as a personal document between equipment processes 3.6 test method method for testing characteristics of identification cards and related interface devices for the purpose of confirming their compliance with International Standards
ISO IEC 10373-3:2010 pdf download – Identification cards — Test methods — Part 3: Integrated circuit cards with contacts and related interface devices
