ISO IEC 17310:2000 pdf download – Information technology — Telecommunications and information exchange between systems — Private Integrated Services Network — Mapping functions for the employment of 64 kbit/s circuit mode connections with 16 kbit/s sub-multiplexing.
1 Scope This International Standard defines the mapping functions in exchanges of Private Integrated Services Networks (PISNs) required for the utilization of scenarios in which 64 kbit/s circuit mode connections are sub-multiplexed into 4 x 16 kbit/s channels for carrying inter-PINX signalling and user information. NOTE 1 – This International Standard has been prepared to meet the specific needs of an application for a particular user organisation. However, it may also be applicable elsewhere. The requirements contained in this International Standard will be incorporated in any future standard specifying a more generic approach to bearer conditioning. In order to connect a Private Integrated Services Network Exchange (PINX) to another PINX, mapping functions are required to adapt the specific interfaces at the C reference point to the application at the Q reference point. As such, mapping functions provide for physical adaptation to the interface at the C reference point. Mapping functions also provide for the mapping of user channels and signalling information at the Q reference point to the appropriate channels or timeslots at the C reference point. The C and Q reference points are defined in ISO/IEC 11579-1. The type ofinterface at the C reference point covered by this International Standard is the 64 kbit/s Unrestricted Digital Leased Line (D64U) Terminal Equipment Interface, in accordance with ITU-T Rec. G.703. At the Q reference point the mapping provides a 16 kbit/s service for user channels to support the transfer of unrestricted digital information and to support the transfer of speech, and a packet mode service for the signalling channel. The applied mapping is a static mapping, i.e. there is a fixed relationship between user and signalling channels at the Q reference point and the interface at the C reference point. Management functions relating to failure management are outside the scope ofthis International Standard. This International Standard is applicable to PINXs that can be interconnected to form a Private Integrated Services Network (PISN) and that support signalling protocols at the Q reference point. 2 Conformance In order to conform to this International Standard, a PINX shall satisfy the requirements identified in the Implementation Conformance Statement (ICS) proforma in annex A. 3 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members ofISO and IEC maintain registers ofcurrently valid International Standards. ISO/IEC 11579-1:1994, Information technology — Telecommunications and information exchange between systems — Private Integrated Services Network — Part 1: Reference configuration for PISNexchanges (PINX).
ISO IEC 17310:2000 pdf download – Information technology — Telecommunications and information exchange between systems — Private Integrated Services Network — Mapping functions for the employment of 64 kbit/s circuit mode connections with 16 kbit/s sub-multiplexing
